Table of Contents
Advertisement
General
1.2 About This Document
This document enables the intended use of the described system. Observing all specified
instructions and all safety instructions is the prerequisite for safe work. Furthermore, the local
accident prevention regulations and general safety conditions for the use of the system are
also described.
If this document refers directly or indirectly to laws, regulations, or directives from them, the
manufacturer cannot be held responsible for the correct, complete or up-to-date nature of
the reference.
Observe the applicable guidelines, standards, and statutory legislation of the respective coun-
try of deployment.
The manufacturer reserves the right to make modifications resulting from further develop-
ments while retaining the key features of the system described without making corrections to
this document.
1.3 UL Approved Systems
In addition to this manual, the following must be taken into consideration for UL Approved
fire extinguishing systems:
•
NFPA 2001 for installation, maintenance and testing requirements
•
Use of clean agent system unit in accordance with the Environmental Protection Agency's
Significant New Alternatives Program (EPA's SNAP)
Monitoring of the electrical release devices
Electrical release devices are used as activating devices of a fire extinguishing system and
NFPA 2001 requires these devices to be in place and ready to use.
During installation, service, and inspection it is common to demount the electrical release
devices. Supervisory switches shall be installed to send a signal to the fire detection and extin-
guishing control panel if the electrical release devices are not in place.
•
Wiring methods for the electrical release devices are to be in accordance with the provided
installation instructions for the UL Listed fire detection and extinguishing control panel.
6
Operator's Manual | Oxeo PR LCP | F_101821 Rev 02 | 08-2022 | en
Advertisement
Table of Contents
