Table of Contents
Advertisement
Operation
As an option, the pay station's POSlinq™ middleware can be installed to provide communication with the POS control
unit software. The sections in this chapter describe the pay station operation using the POSlinq™ middleware.
After having switched the pay station on and started your POS software you can also start the POSlinq™ middleware:
1
Double-tap the POSlinq™ software icon [1] on the POS desktop for instance [A] or select from the start
menu [A].
While the loading screen [2] is displayed the middleware is started and the coin and banknote recyclers are ini-
tialized. This can take a few minutes.
2
Wait until the Start Up OK message [3] and then the middleware's Terminal interface [4] comes up showing the
pay station status
The input funnel LED stops flashing and is white now [5]. The banknote bezel LEDs are off [6].
3
If necessary, in your POS software, establish communication with the POSlinq™ middleware.
4
Tap the user icon [7] on the middleware's Terminal interface [B].
A dialog box [8] asks you to enter your log-in data.
5
Use the on-screen numeric pad [9] to enter your user ID and password and confirm with Validate [C].
The user icon is now showing your user ID [10]. After a while, the Terminal interface closes and a status indi-
cator [11] should flash green in the top left screen corner above a star icon, the color of which depends on your
user rights.
48
When starting the POSlinq™ software you have to log in with your user ID and password provided
by your POSlinq™ software administrator.
49
.
Starting POSlinq™
Paypod™ Embedded Pay Station
POSlinq™ Loading Screen and Terminal Interface
Published by CPI
44000-UG-01-01-EN_CPI_Paypod Embedded Pay Station_User Guide_V1.1.pdf
Advertisement
Table of Contents
