Table of Contents
Advertisement
Published by
CPI • CRANE PAYMENT INNOVATIONS
3222 Phoenixville Pike, Suite 200
Malvern, PA 19355 • USA
Paypod™ • © 2021 Crane Payment Innovations • CPI All rights reserved.
CPI, Paypod™ and POSlinq™ are trademarks of Crane Payment Innovations. Except as permitted under the relevant local legislation, no part of this publication may be copied, transmitted,
transcribed or distributed in any form or by any means, or stored in a database or retrieval system, or translated into any language (natural or computer) without the prior written permission
of Crane Payment Innovations (CPI).
Document Data
Information in this document may change without notice.
Part no.:
44000UG0101EN v1.1
Release version:
V1.1
Edition date:
Tuesday, September 21, 2021
PCN no:
–
Disclaimer
CPI does not accept liability for any errors or omissions contained within this document. CPI shall not incur any penalties arising out of the adherence to, interpretation of, or reliance on,
this standard. CPI will provide support for this product in accordance with the standard warranty of CPI, subject to any modifications to that warranty agreed in writing by CPI. CPI reserves
the right to amend, improve or change the product referred to within this document or the document itself at any time.
Elix and Hoover are trademarks of their respective holders. Use of them does not imply any affiliation or endorsement by them.
Compliance
Paypod™ pay station has been evaluated and is compliant with UL/CSA/IEC 62368-1, audio/video, information and communications technology equipment – Part 1: Safety requirements.
The Paypod IS pay station models can use radio energy to communicate via Bluetooth Low Energy (BLE) or Wi-Fi.
· Meets Radio Equipment Directive 2014/53/EU
· Contains FCC ID: N6C-SDPAC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesirable operation.
To be sure that human exposure to RF energy does not exceed the guidelines in the relevant standards, always follow these instructions:
– A minimum of 20 cm (8 in) distance be maintained between the antenna and all persons and must not be co-located or operated in conjunction with any other antenna or trans-
mitter.
– Only the antenna supplied with this device to be used. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
· Contains IC: 4908A-SDPAC
This device contains license-exempt transmitter/receiver that complies with Innovations, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to
the following two conditions:
– This device may not cause interference.
– This device must accept any interference, including interference that may cause undesired operation of the device.
This product or parts of it must be disposed of through a licensed WEEE (waste electrical and electronic equipment) collection point according to directive 2012/19/EU. Before recycling
the product the battery must be removed and disposed of at a licensed collection point in compliance with directive 2006/66/EC.
Advertisement
Table of Contents
