Cooling Down Temperature; Fan Pulsed Operation; Service; Clean Out The Airways - Miele PDR 914 Operating And Installation Instructions

Cooling down temperature

The laundry will be cooled down automatically before the end of the programme. The
automatic cooling-down phase which takes place before the end of a programme can be
set at a cooler level for all programmes. This means that the cooling phase is extended.
Changing this setting leads to increased energy consumption.
The setting can be changed from 40°C–55°C.
Factory setting: 55°C

Fan pulsed operation

The fan operates intermittently to release laundry that is stuck in front of the inner drum
door.
The fan is switched on and off at certain intervals.

Service

Clean out the airways

The tumble dryer's electronics calculate the degree at which fluff or detergent residue in
the fluff filters and air ducts are impairing performance. A message to check them
appears. You can decide at what level of fluff this reminder should be displayed.
This prompt, which you can configure, is displayed:
filter.
Off
-
The reminder does not appear. However, if there is a very severe blockage in the ducting,
the programme will be cancelled and the reminder will appear in the display regardless of
this option.
Heavy
-
The reminder only appears when there is a heavy build-up of fluff.
- Factory default setting: Normal
Light
-
The reminder appears when there is only a small build-up of fluff.

Clean the filters

The fluff filter in the air duct area must be cleaned on a regular basis. You can set an
hourly interval for the reminder.
The selected hourly interval depends on how much fluff tends to build up and how often
you wish to clean the filters, e.g. for hygiene purposes.
You can adjust this reminder:
- Time interval of 5–55 hours
- Factory default setting: after 55 hours
- Off
Clean the filters
Supervisor level
Clean the fluff filter and rinse the plinth
47