Further Cooling; Cooling Down Temperature; Door Opening Status; Service - Miele PDR 910 EL SOM Operating And Installation Instructions

Commercial tumble dryer
Hide thumbs Also See for PDR 910 EL SOM:
Table of Contents

Advertisement

Cottons
Drying levels
levels.
Factory default: normal

Further cooling

If extended cooling is activated, the drum temperature is checked approx. 1 minute be-
fore the machine goes into standby mode at the end of the programme. If the temperature
is above 55 °C, the dryer will carry out cooling until it is below 55 °C.
Changing this setting leads to increased energy consumption.
- Factory default: off
- On

Cooling down temperature

The laundry will be cooled down automatically after the end of the programme. The auto-
matic cooling phase can be set at a cooler level for all programmes. This means that the
cooling phase is extended.
Changing this setting leads to increased energy consumption.
The setting can be changed from 40 °C–55 °C.
Factory default: 55 °C

Door opening status

If programme interruption in the event of door opening is activated, the tumble dryer re-
mains in the current programme when the door is opened and the programme continues
once the door has been closed and the Start/Stop button has been pressed.
Cancel programme
- Factory default:
Interrupt programme
-

Service

Clean out the airways

The tumble dryer's electronic module calculates the degree to which fluff or detergent
residues in the fluff filters and vent ducting are impairing performance. A message to
check the contamination appears. You can decide at what level of fluff this reminder
should be emitted.
If the message appears on the display even though the fluff filter is clean, the vent ducting
is regarded as borderline. Miele recommends improving the vent ducting. Poor vent duct-
ing will result in longer programme running times and greater energy consumption.
This reminder, which you can configure, is displayed:
Off
-
The reminder does not appear. However, if there is a very severe blockage in the ducting,
the programme will be cancelled regardless of this option.
Heavy
-
The reminder only appears when there is a heavy build-up of fluff.
Minimum iron
Automatic plus
,
and
Supervisor level
can be set to one of 7 different
Clean out the airways
51

Advertisement

Table of Contents
loading

Table of Contents