Drying
At the end of the
programme
Removing the
laundry
Care notes
Prerequisite for
setting the timer
Setting the timer
28
When using the programmes for the first time, the displayed time
sometimes deviates significantly from the real time left. The
difference between the estimated and achieved time becomes
smaller if the corresponding programme is run more often. If
different load sizes are dried in one programme, the time left display
can only show an approximate time.
At the end of the programme
The laundry is cooled down shortly before the end of the programme.
Finish/Cooling down
The message
cooling phase. The laundry can then be removed.
After the cooling phase and the drying programme is completed, the
Finish
message
is displayed.
The tumble dryer will switch off automatically after the set time after
the end of a programme.
If the Anti-crease * Extra has been selected, the drum continues to
rotate in intervals after the end of the programme. This reduces
creasing if the laundry cannot be removed straight away.
* The Anti-crease function is switched off as the factory default
setting and can be activated in the Supervisor level.
Open the door.
Make sure that you empty the drum completely.
Items left in the dryer could be damaged by overdrying when the
dryer is used the next time.
Always remove all items from the drum.
Switch the tumble dryer off by pressing the button.
This tumble dryer requires regular maintenance, particularly if it is
used on a continuous basis. See "Cleaning and care".
Timer
The Delay start must be activated in the Supervisor level in the
Controls / Display menu so that the Timer can be selected. Before the
programme starts, the Timer can be used to select a programme start
time or programme end time.
Timer
Touch the
sensor.
Finish at
Select the
Set the hours and the minutes and confirm your entry with the
OK
sensor.
will appear in the display during the
Start in
Start at
,
, or
option.