Hot Water Connection (Only For Hot Water-Heated Variants); Gas Connection (Only For Gas-Heated Variants) - Miele PDR 914 Operating And Installation Instructions

Installation
36
Hot water connection (only for hot water-heated
variants)
The hot water connection may only be carried out by a registered
installation technician.
The installation instructions must be observed as they are important
for the hot water connection.
If a tap is desired, it must be fitted on site.

Gas connection (only for gas-heated variants)

The gas connection must only be carried out by a registered
installation technician in accordance with the applicable national
regulations (see installation instructions).
The gas heating is configured at the factory in line with the gas
specifications on the sticker on the rear of the appliance.
If the gas type is changed, a conversion kit must be requested from
the Miele Professional Service Department (please specify the
appliance type, serial number, gas type, gas group, gas connection
pressure and country of installation). Follow the installation
instructions. This conversion may only be carried out by a registered
specialist.
A gas appliance shall be installed such that the surface temperature
of any nearby combustible surface will not exceed 65 °C above
ambient.
 Risk of electric shock and injury due to using the tumble dryer
without the complete casing.
If the casing is dismantled, it is possible to come into contact with
live or rotating machine parts.
Once the tumble dryer has been installed, replace all the casing
parts that were removed.