Volume
The volume for various signal tones can be changed.
The volume can be changed for the following sounds:
-
Finish tone
The end tone signals the end of a drying programme.
Keypad tone
-
Welcome tone
-
Fault alarm
-
The fault tone signals an fault and can be switched off. The volume of the fault tone
cannot be changed.
Res. moisture display
In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
without percentage value
- Factory setting:
with percentage value
-
Visibility parameters
Various parameters are offered/displayed when a programme is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited
during programme selection.
Residual moisture
-
Duration
-
Low temperature
-
Anti-crease
-
Load size
-
-
Drying temperature
"Display" off status
The display switches off to save energy; only the Start/Stop sensor flashes slowly. This
can be changed.
Changing this setting leads to increased energy consumption.
Off
-
No switching off
On (10 min.) Not curr.prog.
-
The display will remain on while the programme is running, but will go out 10 minutes
after the end of the programme.
-
Logo (10 min.) Not curr.prog.
The display will remain on while the programme is running, but the logo will light up
10 minutes after the end of the programme.
Supervisor level
41