Table of Contents
Advertisement
60
1-2. Child safety
With rigid lower attachments
4
Latch the buckles onto the lower
anchorages.
5
If the child restraint has a top tether
strap, follow the child restraint man-
ufacturer's operation manual
regarding the installation, using the
top tether strap to latch onto the
top tether strap anchor. (P.63)
6
After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
(P.55)
When installing in the rear center
■
seat
There are no lower anchorages behind
the rear center seat. However, the
inboard lower anchorages of the out-
board seats, which are 18.5 in. (470
mm) apart, can be used if the child
restraint system manufacturer's
instructions permit use of those
anchors with the anchor spacing
stated.
Child restraint systems with rigid lower
attachments cannot be installed in the
center seat. This type of child restraint
system can only be installed in the out-
board seat.
When using an "i-Size MIDI" (for Puerto
■
Rico)
Adjust the support leg and ISOFIX connec-
tors as follows:
1
Lock the ISOFIX connectors where
number 2 can be seen.
2
Lock the support leg where 7 holes
can be seen.
WARNING
■
When installing a child restraint sys-
tem
Observe the following precautions.
Failure to do so may result in death or
serious injury.
When using the lower anchorages, be
●
sure that there are no foreign objects
around the anchors and that the seat
belt is not caught behind the child
restraint system.
●
Follow all installation instructions pro-
vided by the child restraint system
manufacturer.
Advertisement
Table of Contents
