Lexus RX350 2023 Manual page 106

106
3-2. Opening, closing and locking the doors
Multi-information
Unlocking function
display/Beep
Holding the driver's
door handle unlocks
only the driver's
door.
Holding any of the
Exterior: Beeps 3
passenger door
times
handles unlocks all
the doors.
Holding a door han-
dle unlocks all the
doors.
Exterior: Beeps
twice
To prevent unintended triggering of the
alarm, unlock the doors using the wireless
remote control and open and close a door
once after the settings have been changed.
(If a door is not opened within 60 seconds
after is pressed, the doors will be
locked again and the alarm will automati-
cally be set.)
In a case that the alarm is triggered, imme-
diately stop the alarm. (P.71)
■ Impact detection door lock release sys-
tem
If the vehicle is involved in a severe frontal
or rear collision, manual release handle
operation will be enabled for all of the
doors.
■ Operation signals
Doors:
A buzzer sounds and the emergency flash-
ers flash to indicate that the doors have
been locked/unlocked. (Locked: Once;
Unlocked: Twice)
Windows and moon roof or panoramic
moon roof:
A buzzer sounds.
■ Security feature
If a door is not opened within approximately
60 seconds after the vehicle is unlocked,
the security feature automatically locks the
vehicle again.
■ When the door cannot be locked by the
lock sensor on the surface of the door
handle
When the door cannot be locked even if the
lock sensor on the surface of the door han-
dle is touched by a finger, touch the lock
sensor with the palm.
When gloves are being worn, remove the
gloves.
Door lock buzzer
■
If an attempt to lock the doors using the
smart key system is made when a door is
not fully closed, a buzzer will sound continu-
ously for 5 seconds. Fully close the door to
stop the buzzer, and lock the doors again.
■ Setting the alarm
Locking the doors will set the alarm system.
(P.71)
■ Conditions affecting the operation of
the smart access system with push-but-
ton start or wireless remote control
P.127
■ If the smart access system with
push-button start or the wireless remote
control does not operate properly
Use the mechanical key to lock and unlock
the doors. (P.510)
Replace the key battery with a new one if it
is depleted. (P.460)
■ If the battery is discharged
The doors cannot be locked and unlocked
using the smart access system with
push-button start or wireless remote con-
trol. Lock or unlock the doors using the
mechanical key. (P.510)