2
Remove the light bulb.
3
Install a new light bulb and then
install the bulb base to the light unit
by inserting it and turning it clock-
wise.
After installing the bulb base, wiggle it
lightly to make sure it is securely installed
and turn the lights on to visually check that
there is no light leaking from between the
bulb base and light unit.
WARNING
To prevent injury
■
Before performing any light bulb
replacement procedure, be sure to turn
the engine switch off. Failure to do so
may result in burns from hot components
or a part of your body may get caught on
an operating component, possibly caus-
ing serious injury.
6-3. Do-it-yourself maintenance
■
Replacing light bulbs
Turn off the lights. Do not attempt to
●
replace the bulb immediately after
turning off the lights.
The bulbs become very hot and may
cause burns.
Do not touch the glass portion of the
●
light bulb with bare hands. When it is
unavoidable to hold the glass portion,
use and hold with a clean dry cloth to
avoid getting moisture and oils on the
bulb.
Also, if the bulb is scratched or
dropped, it may blow out or crack.
●
Fully install light bulbs and any parts
used to secure them. Failure to do so
may result in heat damage, fire, or
water entering the headlight unit. This
may damage the headlights or cause
condensation to build up on the lens.
●
Do not attempt to repair or disassem-
ble the light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious
injury due to electric shock.
■
To prevent damage or fire
Make sure bulbs are fully seated and
●
locked.
Check the wattage of the bulb before
●
installing to prevent heat damage.
467
6