Lexus RX350 2023 Manual page 278

278
4-5. Using the driving support systems
vehicle-to-vehicle distance setting will
change as follows:
If a preceding vehicle is detected, the pre-
ceding vehicle mark will be displayed.
Vehicles without a head-up display

Vehicles with a head-up display

Illus-
Vehi-
tration
cle-to-vehicle
Num-
distance
ber
1
Short
2
Medium
Illus-
tration
Num-
ber
The actual vehicle-to-vehicle distance var-
ies in accordance with the vehicle speed.
Also, when the vehicle is stopped by sys-
tem control, it will be stopped at a certain
distance from the preceding vehicle,
depending on the situation, regardless of
the setting.
Operating conditions
■
The shift position is in D.
●
● The desired set speed can be set when
the vehicle speed is approximately 20
mph (30 km/h) or more.
• If the vehicle speed is set while driving at
below approximately 20 mph (30 km/h),
the set vehicle speed will be approxi-
mately 20 mph (30 km/h).
• If the vehicle speed is set while driving at
a speed that exceeds the system's upper
limit, the set vehicle speed will be the sys-
tem's upper limit.
Accelerating after setting the vehicle
■
speed
Approximate Dis-
As with normal driving, acceleration can be
tance (Vehicle
performed by depressing the accelerator
pedal. After accelerating, the vehicle will
Speed: 60 mph
return to the set vehicle speed. However,
[100 km/h])
while in vehicle-to-vehicle distance control
mode, the vehicle speed may decrease to
Approximately 85
below the set vehicle speed in order to
ft. (25 m)
maintain the distance from the preceding
vehicle.
Approximately
100 ft. (30 m)
When the vehicle is stopped by system
■
control during follow-up cruising
● When the "RES" switch is pressed while
the vehicle is stopped by system control,
if the preceding vehicle starts off within
approximately 3 seconds, follow-up
Approximate Dis-
Vehi-
tance (Vehicle
cle-to-vehicle
Speed: 60 mph
distance
[100 km/h])
Approximately
3
Long
145 ft. (45 m)
Approximately
4
Extra long
200 ft. (60 m)