Table of Contents
Advertisement
Vehicles with Digital Rearview Mir-
ror
Programming a device other than
an entry gate (for U.S.A. owners)
Press and hold the remote control
transmitter button until the Home-
®
Link
indicator light changes from
slowly flashing orange to rapidly flash-
ing green (rolling code) or continu-
ously lit green (fixed code), then
release the button.
Programming an entry gate (for
U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control
transmitter button at 2 second inter-
vals, repeatedly, until the HomeLink
indicator light changes from slowly
flashing (orange) to rapidly flashing
(green) (rolling code) or continuously
lit (green) (fixed code).
®
4
Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
®
HomeLink
indicator light illumi-
nates: Programming of a fixed code
device has completed. The garage
door or other device should operate
5-5. Using the other interior features
when a HomeLink
pressed and released.
HomeLink
rapidly: The garage door opener
motor or other device is equipped
with a rolling code. To complete
programming, firmly press and hold
the HomeLink
onds then release it.
If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
Two or more people may be necessary
to complete rolling code program-
ming.
1
Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
®
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
operation by
417
®
button is
®
indicator light flashes
®
button for 2 sec-
®
buttons.
5
Advertisement
Table of Contents
