Table of Contents
Advertisement
322
4-5. Using the driving support systems
Vehicles approaching from the parking
●
spaces next to your vehicle
●
The distance between the sensor and
approaching vehicle gets too close
*
: Depending on the conditions, detection
of a vehicle and/or object may occur.
■
Situations in which the system may not
operate properly
The RCTA function may not detect vehicles
correctly in the following situations:
●
When the sensor is misaligned due to a
strong impact to the sensor or its sur-
rounding area
When mud, snow, ice, a sticker, etc., is
●
covering the sensor or surrounding area
on the position above the rear bumper
When driving on a road surface that is
●
wet with standing water during bad
weather, such as heavy rain, snow, or fog
●
When multiple vehicles are approaching
with only a small gap between each vehi-
cle
When a vehicle is approaching at high
●
speed
●
When equipment that may obstruct a
sensor is installed, such as a towing eye-
let, bumper protector (an additional trim
strip, etc.), bicycle carrier, or snow plow
●
When backing up on a slope with a sharp
change in grade
When backing out of a sharp angle park-
●
ing spot
*
Immediately after the RCTA function is
●
turned on
●
Immediately after the engine is started
with the RCTA function on
When the sensors cannot detect a vehi-
●
cle due to obstructions
●
When towing a trailer
●
When there is a significant difference in
height between your vehicle and the
vehicle that enters the detection area
When a sensor or the area around a sen-
●
sor is extremely hot or cold
●
If the suspension has been modified or
tires of a size other than specified are
installed
If the front of the vehicle is raised or low-
●
ered due to the carried load
●
When turning while backing up
When a vehicle turns into the detection
●
area
Advertisement
Table of Contents
