Table of Contents
Advertisement
Changing to the low beams
■
1
Press the Adaptive High-beam Sys-
tem switch.
The AHS indicator will turn off.
Press the switch to enable the Adaptive
High-beam System again.
Temporarily changing to the low
beams
It is recommended to switch to the low
beams when use of the high beams is
inappropriate or when the high beams
may cause problems or distress to
other drivers or pedestrians nearby.
1
Pull the lever rearward and then
return it to its original position.
The high beams will illuminate while the
lever is pulled, however, after the lever is
returned to its original position, the low
beams will remain on for a certain amount
of time. After this, the Adaptive High-beam
System will operate.
4-3. Operating the lights and wipers
AHB (Automatic High
*
Beam)
*
: If equipped
The Automatic High Beam uses a
front camera located on the upper
portion of the windshield to detect
the brightness of the lights of vehi-
cles ahead, streetlights, etc., and
automatically changes the head
lights between the high beams and
low beams.
WARNING
■
For safe use
Do not overly rely on the Automatic High
Beam. Always drive safely, taking care to
observe your surroundings and turning
the high beams on or off manually if nec-
essary.
To prevent unintentional operation of
■
the Automatic High Beam System
When it is necessary to disable the sys-
tem: P.229
Using the Automatic High Beam
system
1
Press the Automatic High Beam
switch.
215
4
Advertisement
Table of Contents
