Table of Contents
Advertisement
Maintenance Manual
1.
Switch off the main power supply to Motor Controller by turning off the S1 isolating switch.
2.
Remove the cover on the feedback unit.
3.
Identify the defective limit switch [2].
4.
Loosen the screws [1] on top of the switch assembly.
5.
Using a soldering iron, release the wiring from the switch.
6.
Solder the wiring to the new limit switch.
7.
Tighten the screws [1] on top of the switch assembly.
8.
Switch on the power by turning the S1 isolation switch inside the motor controller.
9.
Adjust the limit switch as detailed in chapter
Unit.
10. Install the cover on the feedback unit.
KONGSBERG PROPRIETARY. This document and its accompanying elements contain KONGSBERG
information which is proprietary and confidential. Any disclosure, copying, distribution or use is prohibited if not
otherwise explicitly agreed with KONGSBERG in writing. Any authorized reproduction, in whole or in part, must
include this legend. ©2022 KONGSBERG - All rights reserved.
Replacement of Limit Switches in Feedback Units
11.17 Adjustment of Limit Switches in Feedback
P a g e
61 |
73
Advertisement
Chapters
Table of Contents
