Adjustment Of Limit Switches In Feedback Unit - Kongsberg Frydenbo IRV-2 Maintenance Manual

Maintenance Manual
1. Set the Steering Gear Motor Controller switches to position 3
"LOCAL CONTROL".
2. Remove the cover of the feedback unit which limit switches
are to be adjusted.
3. Loosen the nut installed on top of the cam rings.
4. Use a hexagonal key to open the locking screws [2].
5. Move the Steering Gear to the limit switch position.
The tripping cams are adjusted to interrupt the steering signal at
max. electrical rudder angle. This value can be found in chapter 5
of the Electrical User Manual.
6. Adjust the position of each ring [2].
7. Tighten the locking screws [1] using a hexagonal key.
8. Replace the feedback unit cover.
KONGSBERG PROPRIETARY. This document and its accompanying elements contain KONGSBERG
information which is proprietary and confidential. Any disclosure, copying, distribution or use is prohibited if not
otherwise explicitly agreed with KONGSBERG in writing. Any authorized reproduction, in whole or in part, must
include this legend. ©2022 KONGSBERG - All rights reserved.

Adjustment of Limit Switches in Feedback Unit

P a g e 52 |
73