Table of Contents
Advertisement
Maintenance Manual
WARNING
▪
ELECTROSTATIC DISCHARGES CAN DAMAGE COMPONENTS.
▪
TO PREVENT DAMAGE ALWAYS USE A GROUNDED ELECTROSTATIC DISCHARGE
BRACELET WHILE WORK IS ON GOING.
1.
Switch off the main power supply to motor
controller by turning the S1 isolating switch.
2.
Open the control system cabinet.
3.
Use the EDS wristband.
4.
Remove the defective selector card [1]
5.
Set the jumper settings on the new card to
the same as the defective card.
6.
Install the new card.
7.
Close the controls system cabinet.
8.
Switch on the S1 isolation switch in the motor
controller.
KONGSBERG PROPRIETARY. This document and its accompanying elements contain KONGSBERG
information which is proprietary and confidential. Any disclosure, copying, distribution or use is prohibited if not
otherwise explicitly agreed with KONGSBERG in writing. Any authorized reproduction, in whole or in part, must
include this legend. ©2022 KONGSBERG - All rights reserved.
Replacement of Selector Card
P a g e
58 |
73
Advertisement
Chapters
Table of Contents
