Installation; Safety Cable - ETC ColorSource CYC Installation Manual

ETC Installation Guide
ColorSource CYC v1.6

Installation

Mounting
The ColorSource CYC is
designed for floor
mounting. You can also use
the yoke accessory
(included) for top-hang
pipe mounting with a
C-clamp. Use the included
yoke locking knobs and
washers (see image at right)
to attach the yoke
accessory to the fixture. Tilt
the fixture so that the base
of the fixture is
perpendicular to the cyclorama. See

Safety cable

The safety cable (or other approved safety device) must be attached to the
fixture when it is mounted using the optional yoke and C-clamp (see image
above).
Connectors
• Power: Two powerCON
• Data (DMX512/RDM): Two five-pin XLR connectors
connectors for data in and thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Note: This fixture is not Ethernet/data network compatible.
Note: The ColorSource CYC is not self terminating. You must
ColorSource CYC v1.6
®
connectors for power in and thru
terminate the last fixture in line with a 120 Ohm resistor.
XLR terminators are not available from ETC.
To purchase an RJ45 terminator, please contact your ETC
customer service representative and request part
number N4086.
Page 3 of 12
Safety cable
anchor point
Adjusting the tilt
on
Yoke
locking
knob
Washer
page 4
.
OR
two RJ45
ETC