Installation; Safety Cable - ETC ColorSource PAR v1.7 Installation Manual

ETC Installation Guide
ColorSource PAR v1.7/v3.0

Installation

Mounting
The ColorSource PAR ships with a standard yoke for mounting with a clamp.
An expandable floor stand yoke is available as an optional accessory. Contact
your local dealer for more information.

Safety Cable

A safety cable (or other approved safety device)
must be attached to the fixture. Attachment
loops are on the rear of the fixture. Leave as little
slack as possible in the safety cable to avoid
catching the yoke of the fixture.
Connectors
Power: Two powerCON
•
Data (DMX512/RDM): Two five-pin XLR connectors OR two
•
RJ45 connectors for data in and thru
Conversion cables are available from ETC. Please contact your ETC customer
service representative and request part number W6538 for RJ45 to female
XLR or part number W6539 for RJ45 to male XLR.
Note:
Note:
terminate the last fixture in line with a 120 Ohm resistor. To purchase
a terminator, please contact ETC customer service and request part
number N4086 (RJ45 terminator) or SGE1507 (XLR terminator).
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of the
fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
4. Plug the power cord into the power source.
ColorSource PAR
This fixture is not Ethernet/data network compatible.
The ColorSource PAR is not self terminating. You must
®
connectors for power in and thru
Connectors above
Page 5 of 16
.
Safety cable
attachment
loop
ETC