Install Controller
Please follow these steps prior to installing inside escutcheon to prevent
any damage caused by pinching wires:
1. Once wires are arranged, position controller at a rotated angle against the
door, under the earth ground wire.
2. Press piece against door while turning clockwise (Fig. 9E).
3. Twist into place, perpendicular with door (Fig. 9F).
4. Position green/yellow ground wire ring terminal (from lock body)
over hole for top left screw (Fig. 9F, G).
5. Position green/yellow reader harness earth ground on top of ground ring
and thread both with (1) 8-32 x 3/8" Phillips flat head undercut combo
screw (Fig. 9F, G).
IMPORTANT: Note orientation of ground ring terminals in Fig. 9F-H
6. Tighten securely.
Rotate Clockwise
Inside of
Door
Fig. 9E
Harmony Series H2 Mortise Lock
(2) 8-32 x 3/8" Phillips
Flat Head Undercut
Combo Screw
Fig. 9G
16
A8027G • 800-810-WIRE (9473) • www.sargentlock.com
Fig. 9F
Fig. 9H