Table of Contents
Advertisement
Harmony Series H2 Mortise Lock
10 Connector Attachment (Exterior PCB Assembly)
1. Connect P3 (2-pin connector) from lock body
to J3 on module (Fig. 10).
2. Connect P4 (6-pin connector) from lock body
to J4 on module (Fig. 10).
11 Install Inside Escutcheon Assembly
1. Tighten the inside escutcheon securely to the
mounting plate with the Phillips flat head machine
screws provided.
Use the 8-32 x 5/8" for the top of the escutcheon
and the 8-32 x 1/4" screws for the bottom of the
escutcheon located under the turn lever (Fig. 11).
NOTE: The inside gasket (not shown) must be used
when installing Harmony in an outdoor application
(refer to previous Step 6).
2. Be sure the turn assembly is functional
and the deadbolt functions properly.
A8027G • 800-810-WIRE (9473) • www.sargentlock.com
Fig. 10
P3
Fig. 11
17
P4
Inside of Door
8-32 X 5/8" Phillips
Flat Head Undercut
Machine Screw
8-32 X 1/4" Phillips
Flat Head Undercut
Machine Screw
Advertisement
Table of Contents
