Suzuki LT-4WD 1990 Service Manual page 253

7-57 C H AS S I S
Adjust the cab l e as fo l l ows.
By tu rn i n g th e adjust i n g n u ts @ , a l ig n the cab l e
h o l e of t h e sh i ft lever with cab l e eye rod h o l e , a n d
then f i x t h e cab l e t o the stopper of t h e sh ift
l ever side by t i g h ten i n g the adjust i n g n u ts @ .
M atch the p i n h o l e with the n otch ( 4W D position
p i n from th e i nside of the sh ift l ever b racket a nd
i n sta l l an E-ri n g to the p i n correct l y . ( F ig. 6 )
[ 2 ] R A N G E L E VE R C A B L E
F u ndamenta l ly, u se the sam e p roced u re a s that
for the se lectio n l ever cab l e . The o n l y d ifferen ces
are as described be l ow.
Set the sh ift l eve r to the
I I
the L " range position on the cra n kcase. ( F ig. 7,
F ig . 8) refer to that for the se lectio n l eve r cable,
but the word " d iffere n c i a l case" shou l d be rep laced
with "cran kcase" and "stopper on the frame"
with "ca b l e stopper o n the cra n kcase" .
By putt i n g the p i n through t h e p i n h o l e, fasten
the cab l e and l ever , and secru e i n sta l l ation w ith
a n E-ring. (The p i n can be put th rought in either
d i rection. )
[ 3 ] R E V E R S E C A B L E
Set the sh ift l ever to the neutra l position and
se l ect the neutra l position o n the cran kcase.
The sh ift l ever is in the neutra l position when
the end face of the U - sh aped b racket contacts
the body stopper. ( F ig. 8 )
F o r the rest of t h e i n sta l l ation and adj ustment
proced u re, refer to that for th e su b-transm ission
cab l e.
I I
L" ran ge and se lect
Fig . 8
position
4WD
notch