Thales VesseLINK Certus 350 User Manual page 90

NOTE
Section
Read or Activate GPIO Pins
Pin 6
Pin 13
Satellite Connectivity
Disabled
Monitor Satellite
Connectivity
Output High Connected State / Disconnected State (choose whether a high output
Signal for signal represents a connected or disconnected state regarding the satellite )
User Manual PN 84469 Rev L
Figure 4-41 Settings
The same pin, either Pin 6 or Pin 13, cannot be used for both the
Read or Activate GPIO Pins feature and the Satellite
Connectivity feature. Separate pins must be used for each.
Table 4-15 Settings
Off/ Input / Active. If Input is selected, the pin will be configured to
read voltage applied to it, and if Active is selected, the pin will be
powered with about 3.3.V.
Off/ Input / Active. If Input is selected, the pin will be configured to
read voltage applied to it, and if Active is selected, the pin will be
powered with about 3.3.V.
/ Enabled

GPIO

GPIO
Value
4-54