Table of Contents
Advertisement
Section
Error Duration
Answer Timeout
Data
NOTE
From the Data page, shown in Figure 4-, data is enabled or disabled and the routing is configured.
The data can be configured to always go through the Iridium satellite system, always go through
the WAN port or go through both, depending on availability of the WAN network.
NOTE
NOTE
User Manual PN 84469 Rev L
When an outbound call fails or an active call ends prematurely due to
an error, a burst of fast-busy tone (a.k.a. congestion tone) is
transmitted to the radio user for this amount of time. Acceptable
values are ≥ 0 msec. (Default value is 2000 msec).
After an outbound call has been placed, how long to wait for the peer
to answer before giving up and terminating the call. Note that the call
attempt may terminate before this timeout is reached if an error is
encountered. Acceptable values are ≥ 0 sec. (Default value is 60 sec).
This is an ADMIN function only. If the user sees this
login as the ADMIN to continue. Otherwise this is a view only
screen.
The WAN port does not have Power over Ethernet (PoE)
capability, so any device plugged into the WAN port needs to
provide its own power source.
The automatic data routing feature does not apply to voice calls.
All voice calls are routed through the Iridium satellite system
100% of the time. The WAN port is only for data.
Value
icon,
4-45
Advertisement
Table of Contents
