Thales VesseLINK Certus 350 User Manual page 8

Hide thumbs Also See for VesseLINK Certus 350:
Table of Contents

Advertisement

SAFETY
The VesseLINK
system should only be installed by a qualified professional installer of Maritime
electronic systems. Improper installation could lead to system failure or could result in injury to
personnel on board the vessel. The following are general safety precautions and warnings that all
personnel must read and understand prior to installation, operation and maintenance of the
VesseLINK
system. Each chapter may have other specific warnings and cautions.
The VesseLINK
for repair in the field by operators or technicians. Covers must remain in
place at all times on the Below Deck Unit (BDU) and Above Deck Unit
WARNING
(ADU) to maintain the warranty terms. Make sure the system is correctly
grounded and power is off when installing, configuring and connecting
components.
This equipment is not designed to be operated in explosive environments
or in the presence of combustible fumes. Operating this or any electrical
WARNING
equipment in such an environment represents an extreme safety hazard.
The BDU contains a small Li-ion hold-up battery. Li-ion batteries have
a very high energy density. Exercise precaution when handling and
CAUTION
testing. Do not short circuit, overcharge, crush, mutilate, nail penetrate,
apply reverse polarity, expose to high temperature or disassemble. High
case temperature resulting from abuse of the cell could cause physical
injury.
Uer Manual PN 84469 Rev L
system is a sealed system and is not meant to be opened
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
LITHIUM ION BATTERIES
SHOCK HAZARD
U
viii

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vesselink certus 200

Table of Contents