Table of Contents
Advertisement
Section
Dial Plan
Disabled / Enabled
Extension Mapping
1-88888
1001
1002
1003
Inbound Iridium Lines
1-88888
1001 - 1003
Section
Device Mapping
POTS
Radio GW
Phone Configuration
Enable Call Log
POTS Impedance
POTS Compliance
NOTE
User Manual PN 84469 Rev L
Table 4-9 Settings
Disabled – when selected, the requirement to dial a "9" before making
a call across Iridium is now disabled. (Note: When disabled, all calls
go across the Iridium constellation and local extension to extension
calls are disabled.) (ENABLED is the default setting)
Additional custom extensions of varying lengths can be added.
Default extension that receives and makes calls on the first Iridium
line. Connected to the first POTS line.
Default extension that receives and makes calls on the second Iridium
line. Connected to the second POTS line.
Default extension-s that receives and makes calls on the third Iridium
line.
Maps each inbound Iridium line to a single extension previously set
up.
Default extensions 1001, 1002 and 1003 are mapped to Line 1, Line 2
and Line 3 respectively
Assigns extensions to POTS 1 and POTS 2 phones
(Note: 2 POTS phones can be attached with a splitter to the POTS
connector.
Assigns extension to the Radio Gateway
Disabled / Enabled (Enabled is the default setting). Call logs display
Active Calls and Call History when the Calls menu item is selected.
Sets the dynamic output of the POTS system to match regional Phone
types (USA, Australia, Europe, UK, USA-Loaded) (USA is the
default setting)
Sets the POTS Compliance to match regional phone types. (USA or
Brazil). (USA is the default setting)
Extensions must begin with a number from 1 to 8 and must have
four (4) or more digits.
Phone
Value
Value
4-33
Advertisement
Table of Contents
