Thales VesseLINK Certus 350 User Manual page 70

VoIP Phone Settings
NOTE
The two VoIP phones that Thales recommends include the CISCO SPA504G and the Grand
Stream GXP2140. Other phones may work with the VesseLINK terminal, however the
functionality cannot be guaranteed.
The two sections below include general recommended settings for the user to get up and running
with the VoIP phones.
 CISCO SPA504G -- The first section shows how to configure the CISCO SPA504G on
the pre-configured extension 1001.
 GRAND STREAM GX2140 -- The second section shows how to configure the Grand
Stream GXP2140 on extension 1002.
CISCO SPA504G
This procedure assumes that the VesseLINK Terminal is starting from its factory reset state and
that the CISCO SPA504G phone is also in its factory reset state. Note, most of the initial settings
for the CISCO phone stay as they are. Only a few of the settings are required to change as
outlined in the steps below.
1.) Connect the CISCO phone to one of the RJ-45 LAN ports on the front of the VesseLINK
Terminal.
2.) View the Management Portal http://portal.thaleslink (or https://portal.thaleslink)). Note
that the SETTINGS PHONE extensions 1001, 1002, and 1003 are pre-configured as
shown in Figure 4-29.
User Manual PN 84469 Rev L
Please use "portal.thaleslink" as the NTP server.
4-34