Table of Contents
Advertisement
Firmware Revert
FIRMWARE REVERT should only be used when a system has
a serious issue and all other troubleshooting tips have been tried.
Call your Service Provider before doing a firmware revert to
NOTE
make sure all other troubleshooting steps have been exhausted.
This restores the previous version FIRMWARE used on the system.
From the Management Portal select SYSTEM RESET FIRMWARE REVERT.
Confirm by selecting YES, FIRMWARE REVERT. The BDU will reboot into the
previous firmware version.
If the unit will not boot to access the Management Portal, a Firmware Revert can be
accomplished by following these steps:
Power down the system.
Remove the SIM card cover exposing the reset hole. Using a straightened paperclip,
insert it into the round hole just to left of the SIM card as shown in Figure 6-3.
Push straight in gently until the paperclip causes the switch to click. At the same time
turn the unit ON by pressing the power button. Hold the paperclip in until the LEDs blink
and then release.
User Manual PN 84469 Rev L
6-7
Advertisement
Table of Contents
