YASKAWA SI-S3 Technical Manual page 9

The Yaskawa warranty does not include damage from shipping. Contact your sales outlet if the option or other
parts appear damaged.
NOTICE Damage to Equipment. Do not use damaged parts to connect the drive and the option. Failure to comply
could damage the drive and option.
• Make sure that the model number on the option nameplate and the model number on the purchase order are the
same. Refer to Option on page 10
• Contact the distributor where you purchased the option or contact Yaskawa or a Yaskawa representative about
any problems with the option.
◆
Option Package Contents
Ground Wire
LED Labels
Installation Manual
*1 GA700 and GA800 drives do not use the ground wire.
*2 Only two screws are necessary to install the option on GA700, GA800, and FP605 drives.
Note:
The LED label for FP605 drives is packaged with the FP605 drive.
◆
Installation Tools
You can use these tools to install the option to the drive:
• A Phillips screwdriver or slotted screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in))
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities. Prepare different screwdrivers for different
screw sizes.
YASKAWA SIEP C730600 85D CANopen Technical Manual
for more information.
Table 3.1 Contents of Package
Option Contents
Option
*1
Screws (M3)
1000-Series
GA500, GA700, GA800
3 Receiving
Quantity
1
1
*2
3
1
1
1
.
*1
9