YASKAWA SI-S3 Technical Manual page 53

13 European Standards
The CE mark indicates compliance with European safety and environmental regulations.
European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for
electronics manufacturers, and the EMC Directive for controlling noise.
It is required for engaging in business and commerce in Europe.
This option displays the CE mark based on the EMC Directive.
EMC Directive: 2014/30/EU
Drives used in combination with this option and devices used in combination with the drive must also be CE
certified and display the CE mark.
When using drives displaying the CE mark in combination with other devices, it is ultimately the responsibility of
the user to ensure compliance with European standards. Verify that conditions meet European standards after
setting up the device.
◆
EMC Directive Compliance
This option is tested according to European standards EN 61800-3:2004+A1:2012 and complies with EMC
Directive. The CE marking is declared based on the harmonized standards.
■
Option Installation
Verify the following installation conditions to make sure that other devices and machinery used with this option
and drive also comply with EMC Directive:
1.
Use dedicated shielded cable for the option and external device (encoder, I/O device, master), or run the
wiring through a metal conduit.
2.
Keep wiring as short as possible and ground the largest possible surface area of the shield to the metal
panel according to
Figure 13.2 Option Installation for CE Compliance: 1000-Series, GA700, GA800
YASKAWA SIEP C730600 85D CANopen Technical Manual
Figure 13.1 CE Mark
Figure 13.2, Figure 13.3, and Figure 13.4.
13 European Standards
53