Table of Contents
Advertisement
OPTIMOD
Security and Pascode Programming
[Skip this step if you do not wish to change the security level or program pascodes at this
time.]
The 6200 has a relatively simple security system. The same pascode is used for local and
remote security. If you plan to use Orban's PC Remote software you must set a pascode
so the software can connect. If you do not plan to use the PC Remote software, setting a
pascode is optional.
A timer that locks out the front panel after a certain period of control inactivity achieves
local protection of the 6200. The
1. Program the pascode.
A)
Press
Setup
Press
B)
SECURITY
C)
Press
SET PASCODE
Turn the knob until the desired number appears.
D)
Press
button to program the next number in the pascode.
E)
Next
F)
Repeat this sequence to program a pascode with up to eight numbers.
A pascode may have one to eight numbers.
G)
When you have finished programming your pascode, press the
soft key to save it. Write it down and keep it in a safe place.
2. Program local lockout.
A)
Press
Escape
Set the desired lockout time (if any).
B)
You can program the lockout delay time (in hours:minutes) from 15 minutes
to 8 hours, or
front panel control and when the front panel automatically locks itself out,
requiring the pascode to re-establish communication with the 6200.
LOCKOUT
button.
soft key.
soft key to access Set Pascode screen.
button to reveal the
LOCKOUT
. This is the time delay between the last access to a local
off
soft key activates this feature.
soft key.
INSTALLATION
SAVE PASCODE
2-35
Advertisement
Table of Contents
