Table of Contents
Advertisement
OPTIMOD
EAS Test
For stations participating in the Emergency Alert System (EAS) in the United States,
broadcast of EAS tones and data can be accomplished in three different ways:
Note: Normal 6200 processing may not allow the full modulation level as re-
quired by EAS standards. It is therefore necessary to temporarily defeat the
6200's processing during the broadcast of EAS tones and data. Placing the
6200 in Bypass mode can defeat the processing. The
allows a fixed gain trim through the 6200. See "Test Modes," on page 3-35 for
more information.
1. Place the 6200 in Bypass mode locally.
Press
A)
Setup
B)
Press
TEST
soft key.
Hold down the
C)
release the soft key.
Begin EAS broadcast.
D)
After the EAS broadcast, resume normal processing:
E)
Press
Setup
Press
soft key.
F)
TEST
Hold down the
G)
lease the soft key. This will restore the processing preset in use prior to the test
mode.
Alternately, you may press
2. Place the 6200 in Bypass mode by remote control. Then program any
two Remote Interface inputs for "test: bypass" and "exit test," respec-
tively. (OPTIMOD-DAB 6200 only)
Press
A)
Setup
B)
Press
REMOTE
Press
C)
Remote Interface
Select the desired Remote Interface input (1–8), using
D)
display additional pages.
Hold down either soft key below the desired Remote Interface input and turn the
E)
control knob to display
With a different Remote Interface input hold down either soft key below the de-
F)
sired input and turn the control knob to display
button.
soft key, turn the control knob to display
MODE
button.
soft key, turn the control knob to display
MODE
Recall
button.
soft key.
soft key.
test: bypass
BYPASS GAIN
button to exit bypass test.
Next
, then release the soft key.
, then release the soft key.
exit test
INTRODUCTION
control
, then
test: bypass
, then re-
operate
and
buttons to
Prev
1-15
Advertisement
Table of Contents
