Table of Contents
Advertisement
2-28
INSTALLATION
Calibrate using Program — feed normal Program material to the 6200.
F)
[Skip this step if you are using Tone to calibrate the 6200 to your standard
studio level — see step (E) above.]
Play program material from your studio, peaking at the level to which you
normally peak program material (typically 0VU if your console uses VU
meters).
Verify
a)
ST CHASSIS
Refer to step 3 on page 2-23 above.
b)
Hold down the
adjust for an average of 10dB gain reduction on the 6200's
Also, observe the
If the
AGC
(higher on the meter), or if the
rial is present, re-adjust the
If the
AGC
meter), re-adjust the
This control has no effect on the AES/EBU digital input.
c)
When finished, reset
prior to setting
4. Adjust R CH BAL (Right Channel Balance).
[Skip this step if the channels are already satisfactorily balanced.]
[−2dB to +2dB] on right channel only, 0.1dB steps
This is not a balance control like those found in consumer audio products.
This control changes gain of the right channel only. Use this control if the
right analog input to the 6200 is not at exactly the same level as the left in-
put. Be certain that the imbalance is not from a certain program source, but
only through distribution between the console output and 6200 input.
Press
button to access Setup screen.
A)
Setup
Press
soft key, then press
B)
I/O CALIB
Press the
button to page to the
C)
Next
as necessary.
5. Adjust the source of the analog output.
[Skip this step if you will not be using the 6200's analog output.]
Press
button.
A)
Setup
B)
Press
I/O CALIB
soft key, then
Set the
C)
MON OUT
sired.
is set to
.
no
AI REF
soft key and use the 6200's front panel control knob to
Gate
indicator. It should go out when program is present.
gain reduction meter averages less than 10dB gain reduction
Gate
AI REF
level to a lower level.
gain reduction meter averages more gain reduction (lower on the
AI REF
level to a higher level.
ST CHASSIS
to
AI REF
level).
ANLG IN CALIB
R CH BAL
ANLG OUT CALIB
control to
(pre limiter) or
pre limt
AGC
indicator stays on when program mate-
yes
, if required (e.g., if that was its setting
soft key.
settings, then adjust the parameter,
soft key.
(post limiter), as de-
post lim
ORBAN Model 6200
meter.
Advertisement
Table of Contents
