Table of Contents
Advertisement
2-32
INSTALLATION
Hold down the
b)
adjust for an average of 10dB gain reduction on the 6200's AGC meter.
Also, observe the
If the
AGC
(higher on the meter), or if the
rial is present, re-adjust the
If the
AGC
meter), re-adjust the
This control has no effect on the AES/EBU digital input.
When finished, reset
c)
prior to setting the
4. Adjust R CH BAL (Right Channel Balance).
[Skip this step if the channels are already satisfactorily balanced.]
[−2dB to +2dB] on right channel only, 0.1dB steps
This is not a balance control like those found in consumer audio products.
This control changes gain of the right channel only. Use this control if the
right analog input to the 6200 is not at exactly the same level as the left in-
put. Be certain that the imbalance is not from a certain program source, but
only through distribution between the console output and 6200 input.
Press
button to access Setup screen.
A)
Setup
Press
soft key, then press
B)
I/O CALIB
C)
Press the
Next
button to page to the
as necessary.
5. Set 6200 USER BITS to receive or block user bits.
[pass], [block].
If you want to transparently pass incoming user bits through to your 6200
digital output, set
.
block
Press
button to access Setup screen.
A)
Setup
Press
soft key, then press
B)
I/O CALIB
Press the
button to page to the
C)
Next
as necessary.
6. Adjust Digital Output level.
[Skip these steps if you will not be using the 6200's digital output. Continue to
step 13 on page 2-34.]
Press
button.
A)
Escape
soft key and use the 6200's front panel control knob to
DI REF
indicator. It should go out when program is present.
Gate
gain reduction meter averages less than 10dB gain reduction
Gate
level to a lower level.
DI REF
gain reduction meter averages more gain reduction (lower on the
level to a higher level.
DI REF
to
ST CHASSIS
level).
DI REF
DIG IN CALIB
R CH BAL
to
USER BITS
pass
DIG IN CALIB
USER BITS
indicator stays on when program mate-
, if required (e.g., if that was its setting
yes
soft key.
settings, then adjust the parameter,
. Otherwise, set this parameter to
soft key.
settings, then adjust the parameter,
ORBAN Model 6200
Advertisement
Table of Contents
