Operation - Kogan KA45CICEMKA User Manual

OPERATION

1. After water pipe connecting is completed, plug in the main power supply plug. Then
press "ON/OFF" button on the control panel to begin the ice making cycle，and the
"ICE" light will be turn.
The digital window will display the ambient temperature normally. When the digits
begin to flash, it will display the remaining time to complete the ice making cycle.
The compressor, fan motor and water pump will run during the ice making process.
2. Each ice making cycle will take approximately 11 to 20 minutes, depending on the
ambient temperature and the water temperature. The initial ice-making cycle may
take little longer.
3. When the ice-making process is over, the unit will switch to the ice-harvest process.
During the ice-harvest process, the "ICE" light will flash and the compressor will still
run.
At same time the system will detect the water level, if the water level is lower than
the setting position. The "ADD WATER" light will start to flashing, open the water
inlet electro-magnetic valve to supply the water to water tank and the floating ball of
the water level detecting switch in the tank will raise. Continue filling the water until
the "ADD WATER" light turns off.
When the ice-harvest finishes, the Ice-full detecting plate will rotate downward once,
then return to the original position and enter into the next ice-making process.
When the unit is full of the ice it will stop making the ice automatically.
4. When the "Full" indicator is on, the unit stops running. If you remove any ice, the unit
will start to make the ice cube again. But it will restart only after 3 minutes of the
compressor running.
5. During the ice-making process, press the "+" or "-" button to adjust the ice-making
process duration.
Automatic self-cleaning program
Start the self-cleaning program: After connecting all the water pipes, connect the main
power supply plug, then press "TIMER CLEAN" button on control panel for more than 5
seconds to enter the self-Cleaning program. The "CLEAN" light will always be on during
this period, the digit window will indicate the left time, the water pump runs for 8 minutes
and stops for 3 minutes. The total duration time is 30 minutes for one self-cleaning
program. When the water pump stops, the water will return to the water tank
automatically.
Cancelling the self-cleaning program: It takes about 30 minutes to complete one self-
cleaning program. When the program is over, the system will be in off-state automatically.
You can press the "ON/OFF" button on control panel to cancel the self-cleaning.
19