Table of Contents
Advertisement
OPERATION
1.
Ensure that the drain plug at the bottom of water reservoir is closed well.
2.
Plug the ice maker into an electrical outlet, the " " indicator will blink.
Note:
if it has been moved, allow the ice maker to rest for 30 minutes before plugging it back
in.
3.
Open the top lid and remove the ice basket.
4.
Fill the water reservoir using potable water only.
Note:
Do not fill above the MAX water level mark.
5.
Replace the ice basket and close the top lid.
6.
Press the "SELECT" key to select the desired ice size.
o
"
" Small ice
o
"
" Large ice.
7.
Press the "ON/OFF" key and the " " indicator lights solidly.
8.
The ice-making cycle will last approximately 7-15 minutes, depending on the
ambient and water temperatures.
9.
The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 7-15 minutes ice forms on the evaporator.
Once completed, the ice tray will tilt backwards and the remaining water in the ice
tray is drained back into the water reservoir. The ice cubes are then dropped from
the evaporator and pushed forward into the ice basket by the ice shovel. The ice
tray will automatically move back into position under the evaporator and start the
next cycle.
10. The "
"indicator will light up when the ice basket is full and then the ice maker
will stop the ice-making cycle automatically. Gently remove the ice from the ice
basket with the ice scoop. About 5 seconds later, the ice maker will restart its ice
making function automatically.
Advertisement
Table of Contents
