Table of Contents
Advertisement
INSTALLATION
Unpacking Your Ice Maker
1. Remove the exterior and interior packaging. Check if all the accessories, including the
user guide, ice scoop, water inlet pipe, 4 into 2 ways water quick connector, and the
water draining pipe are included. If any parts are missing, double check the
packaging and then contact help.Kogan.com for support.
2. Remove any tape from the door and inner cabinet, ice scoop, etc. Clean the inner
cabinet & ice scoop with damp cloth.
3. Put the ice maker on a level and flat surface, without direct sunlight and other
sources of heat (i.e.: stove, furnace, radiator). Make sure that there is at least 20cm
gap between the air outlet and the obstacles and at least 5cm between Left/Right
side and the wall.
4. Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in.
5. The appliance must be positioned so that the plug is easily accessible.
WARNING:
onnect to potable water supply only. Ensure only drinking
C
water is used in this appliance.
Installation Location Requirements
• This unit is not for outdoor use. Keep the proper room temperature and inlet water
temperature according to specification table. Failure to do so will affect the ice
making performance.
• This unit should not be located near any sources of heat.
• The unit should be located on a firm & level foundation at normal countertop height.
• There must be at least 5cm clearance at rear side for connection and 25cm
clearance in front to open the door and keep good air circulation.
• Do not put anything on the top of the ice maker.
13
Advertisement
Table of Contents
