Kogan KA45CICEMKA User Manual page 24

Ice Making Parts Cleaning
• The water dividing pipe on the evaporator will need to be cleaned regularly. If there is
no water flow from the water dividing pipe or the water flowing is restricted, please
discharge this water dividing pipe to clean. Clean each little hole on the water
dividing pipe. Ensure each hole is not clogged, then reinstall to the original location.
• When there are ice cubes on the surface of the evaporator, but can't fall down easily,
do not use any mechanical force to try remove it. Instead press and hold the
"ON/OFF" button for more than 5 seconds, the unit will enter the ice melting process,
after some time, the larger ice-cubes will fall down, then turn off the unit and unplug
the power cord to clean the surface of the evaporator.
For the water tank and ice-full detecting
plate:
The water tank and the ice-full detecting
plate are very important to keep your ice
hygienic. Spray a mixture of neutral cleaner
and water onto all the inner surfaces of tank
and the ice detecting plate. Wipe these
surfaces as far as possible with a clean cloth.
Spray the surfaces with clean water, wiping
with a dry clean cloth. Then drain out the
cleaned water in the water tank by pulling
out the Water drainpipe from the water tank.
When all the water has been drained out, reinstall the water drainpipe to the water tank.
Tip: After cleaning the interior parts and install back to its respective position and return
machine to work, discard first batch of ice.
24
Water diving pipe
Evaporator
Small holes of water diving pipe
Pull up first
Then move out right towards
Ice-full detecting plate
Water tank