Connecting The Flexware; Connecting The Flexware ® Assemblies - Merck Millipore Mobius Chrom 20 System User Manual

138

Connecting the Flexware

There are a number of Flexware
Assembly. The previous section details the installation of these assemblies. This section details
connecting all the Flexware
Assembly numbers in this section are highlighted in RED.
connection tags are highlighted GREEN.
Flexware
®
Connecting the Flexware
1
Install and connect the Flexware
A
B
F
C
E
D
D
C
W
E
V
F
G
H
Connecting the Flowmeters
The Flowmeter outlets must be attached to the Flexware
1. Remove the plugs/caps from the connector labeled
V to the outlet of the flowmeter Assembly labeled V.
2. Connect
3. Remove the plugs/caps from the connector labeled
W
4. Connect
Assemblies that must be connected to the Flexware
®
Assemblies used on the system.
®
2 3
Assemblies in the order presented in this section.
®
G
to the outlet of the flowmeter Assembly labeled W.
Assemblies
®
4 5
H I
Clamshell Assembly.
®
V on the Flexware
W on the Flexware
®
6 7
S
R
Q
P
O
N
M
L
K
J
00013746FM VER3.0
Clamshell Assembly.
®
Clamshell Assembly.
®
User Guide
Clamshell
®
8 9
This drawing and the data contained thereon is confidential
THIS DRAWING IS
and the property of MilliporeSigma, Billerica Massachusetts,
USA. Third Parties may use this document only to review
THE PROPERTY OF
and approve the drawing for use by MilliporeSigma in its
MILLIPORESIGMA
manufacturing. Any other use or reproduction of this
drawing is expressly prohibited without MilliporeSigma's
written consent.
TOLERANCE BLOCK
X ± 1
X.X ± 0.5
X.XX ± 0.25
X.XXX ± 0.125
± 5°
ALL DIMENSIONS IN INCHES
10
DRAWING NU
XM
DESCRIPTION
MO
DRAWN BY:
A. CHA