Installing Peripheral Modules - Keysight M9005A User Manual

Getting Started With The System

Installing Peripheral Modules

This section contains general installation instructions for installing a peripheral
module in a M9005A chassis. Refer to your peripheral module user manual for
specific instructions and warnings. To install a module, complete the following
steps:
1 Inspect the slot for any physical damage or bent pins before installing the
2 Connect the AC power source to the PXI Express chassis before installing the
3 Ensure that the chassis is powered off.
4 Install a module into a chassis slot by first placing the module card PCB into
5 When you begin to feel resistance, push up on the injector/ejector handle to
Keysight M9005A PXIe Chassis User Guide
The M9005A chassis has been designed to accept a variety of
peripheral module types in different slots. To prevent damage to
the chassis, ensure that the peripheral module is being installed
into a slot designed to accept it. Refer to
Backplane Overview"
slot types.
Do not insert a hybrid PXI module (with J1 and XJ4 connectors)
into slot 2 or 3, or pin damage may occur.
peripheral module.
module. The AC power cord grounds the chassis and protects it from electrical
damage while you install the module.
the front of the card guides (top and bottom), as shown in
module to the rear of the chassis, making sure that the injector/ejector handle
is pushed down as shown in
fully seat the module into the chassis frame. Secure the module front panel to
the chassis using the module front-panel mounting screws.
You must install your module driver software provided by the
module manufacturer before using the modules in the chassis.
on page 7, for a description of the various
Figure 12.
Installation and Configuration
"M9005A Chassis
Figure 12. Slide the
25