Table of Contents
Advertisement
2.
Install the leak sensor (optional):
a.
Align the leak sensor's T-bar with the slot in the left-hand side of
the MS-bracket drip tray and slide the leak sensor into place.
Leak sensor
T-bar
b.
Route the leak sensor cable through the slot in the column heater
housing.
3.
Secure the 25-pin cable:
a.
Insert the 25-pin cable into the cable clamp.
b.
Install the cable clamp on the threaded stud inside the column
heater housing, and then thread the 4-mm nut onto the stud.
TP02892
Slot
September, 2019, 715003738IVD Rev. C
Installing the column heater
31
Advertisement
Table of Contents
