Waters ACQUITY UPLC I-Class IVD Overview And Maintenance Manual page 24

2 Preparing the column heater
MS-bracket kit major components:
MS-bracket
Warning:
then allow the column compartment and its components to cool for 60
minutes before touching them. Monitor the column compartment's
internal temperature to ensure that all components are cool.
Caution:
chemical-resistant, powder-free gloves when preparing the column
heater for use with a mass spectrometer.
To install the MS-bracket:
To remove the column heater from the device chassis:
1. Stop any currently running mobile phase.
2. Power-off the sample manager.
24 September, 2019, 715003738IVD Rev. C
Column heater housing
MS drip tray
To avoid burn injuries, set the column temperature to Off, and
To prevent contaminating system components, wear clean,
TP03252
Hinge