Replacing The Column Stabilizer Assembly - Waters ACQUITY UPLC I-Class IVD Overview And Maintenance Manual

manager door to the injector. Do not route the tubing behind the sample
manager door hinge.
6. Remove the O-ring retainer from the inlet end of the active preheater
assembly tubing, and then connect the inlet tubing to port 6 of the
sample manager injection valve.

Replacing the column stabilizer assembly

Warning:
then allow the column compartment and its components to cool for 60
minutes before touching them. Monitor the column compartment
internal temperature to ensure that all components are cool.
Warning:
properly connected and the drip tray is fitted and undamaged. Properly
installing the tubing and drip tray keeps waste or solvent from
contacting the power cord or cables.
Caution:
chemical-resistant, powder-free gloves when replacing the column
stabilizer assembly.
Use the column stabilizer only with the column heater (CH-A). Do not use it
with the column manager or auxiliary column manager.
To avoid burn injuries, set the column temperature to Off, and
To prevent electric shock, ensure that all waste line tubing is
To prevent contaminating system components, wear clean,

Replacing the column stabilizer assembly

Note: Do not route the tubing
behind the sample manager
door hinge.
Active preheater inlet tubing
September, 2019, 715003738IVD Rev. C 73