Required Materials; Required Tools - Waters ACQUITY UPLC I-Class IVD Overview And Maintenance Manual

Process for installing the MS-bracket
Task
Remove the column heater from the device chassis
Install the MS-bracket on the column heater chassis
Attach the column heater housing onto the MS-bracket
Install the column heater and connecting accessories, such as
the MS drip tray, leak sensor, and drain tubing
Install the column and connect inlet and outlet tubing

Required materials

• Column heater MS-bracket kit
– MS-bracket
– Column heater housing
– MS drip tray
– Hinge assembly
– Cable clamp
®
– TORX screws
®
– Phillips
– Cable clamp nut
• Drain tubing
• Clean, powder-free, chemical-resistant gloves

Required tools

• 1/4-inch open-end wrench
• 4-mm open-end wrench
• 3-mm hex wrench
• Phillips screwdriver
• Small, flat screwdriver
• T20 TORX driver
screws
September, 2019, 715003738IVD Rev. C
Installing the column heater
See
page 24
page 25
page 29
page 30
page 34
23