Declaration Of Conformity To Emc - Tomey UD-800 Instruction Manual

8.6 Declaration of Conformity to EMC

 When using specified accessories or cables excluding internal parts sold as
repair parts of TOMEY Corporation, electromagnetic emission of the UD-800 may
increase or electromagnetic immunity may decrease.
 When using handheld or portable communication equipment, locate it more than
30cm(12inches) away from the UD-800. It may degrade the performance of the
UD-800 if the equipment is located closer.
Do not use the UD-800 adjacent to or stacked on other equipment. If it needs to be

adjacent to or placed on other equipment, it must be confirmed that UD-800
operates correctly in such location.
 The UD-800 falls under Group 1, Class B according to EN 55011(CISPR 11). This
means that the UD-800 does not generate RF energy intentionally in the form of
electromagnetic irradiation, inductive coupling and/or capacitive coupling for
processing of materials or inspection/analysis, and that it is suitable for use in
facilities directly connected to a low-voltage power network that supplies power to
general household facilities and buildings used for home use.
 The UD-800 can be used in a specialized health care facility such as hospitals and
clinics (except anywhere near the source of a strong EMI) and a general
commercial facility such as eye glasses stores.
The UD-800 requires special attention for EMC and needs to be installed, serviced

and used based on the following information.
 Do not use cables other than those provided or specified by TOMEY Corporation.
 The person who connects additional equipment to the signal I/O section as part of
the medical system, shall take responsibility for ensuring the system conforms to
IEC/EN 60601-1-2 requirements.
8-9 ■