Adjusting The Squareness Of The Dryer Rack - Kodak X-Omat 1000 Service Manual

SERVICE MANUAL

Adjusting the Squareness of the DRYER RACK

2 SCREWS
FRONT COVER
H164_0035HCA
H164_0035HC
[1] Remove the DRYER RACK.
Important
Do not remove the SCREWS on the COVERS or the REINFORCING BARS.
[2] Loosen the 2 SCREWS on:
• FRONT COVER
• REAR COVER
[3] Place the DRYER RACK on a flat surface with the top down.
Important
The 4 SCREWS and the 4 REINFORCING BARS are not visible in the graphic.
[4] Loosen the 4 SCREWS on one end of the 4 REINFORCING BARS.
[5] Press down on the 2 SIDE PLATES to make uniform contact with the flat surface.
[6] Tighten:
• 4 SCREWS on the 4 REINFORCING BARS
• 2 SCREWS on the FRONT COVER
• 2 SCREWS on the REAR COVER
[7] Install the DRYER RACK into the PROCESSOR.
46
DRYER RACK
2 SIDE PLATES
REAR COVER
2 SCREWS
CHAIN
10SEP02 – 9B8949