3
Control Panel
Control Panel
Run Parameters
The set points for centrifugation can be defined and set in the parameterization window. Clicking one
of these buttons will open a new window in which you can input the appropriate set point value.
Acceleration mode:
Select an acceleration
profile (Level 1-9).
Speed:
Set the speed as RPM
or RCF here.
Program:
Select a program for centrifugation here. The
previously selected program will always be
displayed initially. You can change the
parameters once you have selected a program.
22
Sorvall LYNX 4000 / 6000
Time:
Select the duration for centrifugation and
the Time mode here.
Deceleration
mode:
Select the
deceleration profile
(0-9) here.
Temperature:
Set the
temperature (in
°C) for the rotor
chamber here.
Rotor:
The rotor currently in use is displayed
here (in this case: F12-6x500 LEX).
Thermo Scientific