Step 4: Quickly Configure The Screen - NovaStar MCTRL660 PRO User Manual

Step 2 Choose Input Settings > Color Depth to enter its submenu, select a color depth, and press the knob to apply
it.
Table 6-1 Input bit depth adjustment
Bit Depth
8bit
10bit
12bit

6.1.4 Step 4: Quickly Configure the Screen

Follow the steps below to complete quick screen configuration.
Figure 6-5 Quick configuration
Step 1 On the home screen, press the knob to enter the main menu.
Step 2 Choose Screen Settings > Quick Config to enter its submenu and set the parameters.

Set Cabinet Row Qty and Cabinet Column Qty (numbers of cabinet rows and columns to be loaded)
according to the actual situation of the screen.

Set Port1 Cabinet Qty (number of cabinets loaded by Ethernet port 1). The device has restrictions on the
number of cabinets loaded by the Ethernet ports. See Note a).

Set Data Flow (Front View) of the screen. See Note c), d), and e).
Notes
a). If n ports are used to load the
screen, the number of cabinets loaded
by each of the first (n–1) ports must be
the same and the integral multiple of
the number of cabinet rows or
columns, and it must be greater than
or equal to the number of cabinets
loaded by the last port.
b). For irregular screens, NovaLCT software must be connected to configure the screen.
c). During data flow settings, you can rotate the knob to select a target data flow pattern.
d). During data flow settings, ensure that the cabinets loaded by each Ethernet port are connected one by one
in the same direction.
e). During data flow settings, ensure that Ethernet port 1 is at the beginning position of the whole physical
connection.
www.novastar.tech
Description
The loading capacity of the device will not be reduced.
The loading capacity of the device will be reduced by half. The bit depth must be set.
The loading capacity of the device will be reduced by half. The bit depth must be set.
Example:
If all the 6 Ethernet ports are used to load the screen, the number of
cabinets loaded by ports 1–5 must be the same and the integral
multiple of the number of cabinet rows or columns. Therefore, you
need to set only the number of cabinets loaded by port 1 according
to the actual situation. The number of cabinets loaded by port 6 must
be less than or equal to the number of cabinets loaded by port 1.
MCTRL660 PRO Independent Controller User Manual
13