Chery A1 2009 Service Manual page 515

17. Remove the front engine mount bolts (1) and the
front engine mount bracket bolts (2).
(Tighten: Engine front mount bolt to 80 ± 5 N·m)
18. Remove the rear engine mount bolts (1) and the
rear engine mount bracket bolts (2).
(Tighten: Engine rear mount bolts to 60 ± 5 N·m)
19. Remove the sub-frame mounting bolts (1) (4 total)
between the sub-frame assembly and the vehicle
body.
(Tighten: Sub-frame mounting bolts to 150 ± 10
N·m)
NOTE :
Before removing the front suspension sub-frame from the vehicle, the location of the sub-frame must be marked on
the body of the vehicle. Do this so the sub-frame can be relocated, upon reinstallation, against the body of vehicle in
the same location as before removal. If the front suspension sub-frame is not reinstalled in exactly the same location
as before removal, the preset front wheel alignment settings (caster and camber) may be lost.
20. Remove the front sub-frame.
21. Separate the front lower control arm and the front stabilizer bar from sub-frame assembly.
22. Separate the front strut rod from the sub-frame.
23. Installation is in the reverse order of removal.
22
10–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
PZSM020032
PZSM020011
PZSM100014